Lignum Vitae

Full Guide About Woodworking Hammers

A wide range of Hammers are available, varying in shape, size and weight. The different styles reflect different uses. Around the house, the average diy’er only really needs one or two type.Visit the Woodworking Plans Website pages for more woodworking and tools articles.

The shape of Hammer heads has not changed much over the years although some modern materials are now used in both the head and handle. Traditionally handle were made of wood fixed through a hole in the head; this allowed the handle to be easily replaced if required. Modern hammers use modern materials and the handles are often built into the head – often with a form of built-in shock absorber to make them easier to use.

Claw Hammer

The most popular hammer for general work, available with a wooden (often hickory), glass-fibre or steel handle; with or without rubber grip. The most popular weights are 455-680g (16 to 24oz). The claw is normally curved, and incorporates a ‘V’ cut-out to draw nails from timber. The claw can be used to lever up floorboards or where other places where a lever is required; care must be taken (especially with cheaper models) as the force applied can easily weaken the joint between the handle and the head.

Ball Pein

Normally used by engineer’s, the pein in this case, is rounded and is usually used for shaping metal and closing rivets. Ball pein hammers are available from 55 – 1100 (4 oz upto 2 lb.), 110 – 165g (8oz 12oz) are the most suitable for general use. Handles are normally wood, usually Ash or Hickory.

Cross and Straight Pein

Again, mainly used for shaping metal, the pein can be at right angles to the handle or parallel with it. The most useful domestically is the cross pein, where the pein can be used for starting panel pins and tacks. Handles are normally wood, usually Ash.

Soft-faced Hammers

Various types are available, with hard and soft rubber, plastic or copper faces. Some come with a choice of faces which are interchangeable. Useful for striking materials such as chrome wing outs, where a steel face would cause damage. In some cases, can replace a mallet for cabinet work.

Sledge Hammer

Used for the heavier jobs, such as driving in stakes or to break up concrete, stone or masonry. For lighter jobs just the weight of the head may be used for blow’s, but for heavier work, the hammer is swung like an axe. Wear suitable protective clothing, including safety glasses. Weights 7, 10 and 14 lb.

Joiner’s Mallet

Used to drive chisels or to tap wood joints together, where a metal-faced hammer would cause damage or bruising. Note that the head is slightly tapered to ensure correct contact with the work. Both the handle and head are wood, usually Beech or Lignum Vitae.

Club Hammer

Sometimes called a Lump Hammer, it has a double faced head, and is useful for light demolition work, driving steel chisels and masonry nails. As debris is likely to fly, the Different types of Hammers wearing of safety glasses and working gloves is recommended. Weight 1135g (2 1/2 lb) being best suited to domestic work. Handles are normally wood, usually Hickory, or synthetic resin.

Cross Pein Pin Hammer

A lighter version of the Cross and Straight Pein hammer, ideal for light joinery and cabinet work. Weight 55g (4oz).

About the Author

This author writes about Woodworking 4 Home Plans and Woodworking Plans and Ideas.Visit the Woodworking4Home Review website and get 14000 woodworking plans.

Lignum Vitae